I didn't see this mentioned on the main forum. I wonder if anyone else is experiencing this?
When out exploring and you scan a planet, it usually comes back saying it's a Water World, or Class II Gas Giant, and etc. But if you scan a landable planet, when it's finished scanning the planetary landing approach suite interface is shown, even if you are still 50 or 100 ls away. You have to check the system map to see what type of planet it is. Also, I didn't even see a way to turn off the planetary approach suite.
I don't remember this happening it the bubble. When I selected a planet I usually wasn't worried about what type it was, and had probably already checked that out in the system map, so I probably wasn't looking. And I don't remember the approach software kicking in until I was very close to the planet, but I probably wasn't paying attention because I always use the 6-seconds rule when approaching planets & stations.
Anyway, it seems to me that if you scan a planet, it should always come back with the planet type information. If it wants to replace that info with the approach software when you get closer, then than makes sense too. But then this may be what is already happening with others.



